Temsa TS 35 - Washing New Vehicles

TEMSA TS 35 |15Rev. 08/01.11.13
Washing New Vehicles
Pressure Washing
You can use pressure washers for your vehicle
older than 2 months. Running water and gentle
washing agents approved by TEMSA can be use
for this process.
Wash water Preparation
Use cold or warm water for pressure washing. De-
pending on the manufacturer, you can add 1 to 5 %
washing agent to the wash water.
WARNING
Do not use high pressure round jet nozzles
and power nozzles. Only use at jet nozzles
for pressure washing. Always keep the nozzle
moving instead of pointing. The average
operating pressure of pressure washing ma-
chine should be 725 PSI.
WARNING
New paint work is not fully hardened during
the rst months. Therefore, instead of wash-
ing the vehicle in an automatic wash system
prefer hand wash during the rst 2 months.
Always wash the vehicle starting from top to
bottom.
25
2
25

SPRAYING
POINTED PRESSURE
RIGHT FALSE
Choosing Right Nozzle For Pressure Washing