TEMSA TS 35 |19Rev. 08/01.11.13
Outer Surface Damage
Stone chips, paint damage and scratches in the
painted surfaces should be repaired promptly.
Bare metal will corrode quickly and can develop
into a major expense. Minor chips and scratches
can be repaired with touch- up materials that are
available from your TEMSA Authorized Service
Point.
Accident Damage
Should your vehicle be Involved in an accident and
require sheet metal repair or replacement, ensure
that the body repair shop applies the correct anti-
corrosion material conforming to TEMSA Specica-
tions to the replaced parts and adjacent areas.
Anti-Corrosion
Perforation Requirements
When you receive your new vehicle, please en-
sure that the vehicle details, Vehicle Identication
Number (VIN) and the Warranty Start Date are
correct. Like the periodic maintenance, the body-
work must also be inspected on an annual basis;
this in general is carried out at the same time as
the periodic maintenance. Any minor repairs for
stone chips, scratches and damage etc., are at the
owner’s expense. If the vehicle has been involved
in an accident or for whatever reason and sheet
metal panels have been repaired or replaced, re-
pairs must be performed in accordance with the
procedures laid down in the appropriate repair
manuals.
MANUFACTURED BY:
DATE OF MANUFACTURE : MO. YR.
MODEL: TS 35CTYPE: INTERCITY BUS EPA10
VIN: PROD.NO.:
ENG.NO.: DPF NO.:
GVWR :
16, 986 Kgf ( 37, 448 Ibf)
GVWR - FRONT : 6, 100 Kgf (13, 448 Ibf)
GVWR - REAR : 10, 886 Kgf (24,000 Ibf)
TECHNICALLY PERMISSIBLE
MAXIMUM WEIGHT : 19, 400 Kgf (42, 700 Ibf)
THIS VEHICLE CONFORMS TO ALL APPLICABLE
U.S. FEDERAL MOTOR VEHICLE SAFETY STANDARDS
IN EFFECT ON THE DATE OF MANUFACTURE
SHOWN ABOVE.
TEMSA GLOBAL SANAYİ VE TİCARET A.Ş
To Next Page
Loading...
