Temsa TS35 - Tools; General Safety and Work Environment; Recommended Tools for Service

PRIMER
C ROTAVITAGASOLINE
RUBBER SUCTION
CHOCKRASPER
SEALER CUTTING MACHINE
HAMMER
PLASTIC HAMMER
PHILIPS SCREW DRIVER
GRINDERS
TS35
|
5
02 TOOLS
TS35-U06 / Rev. 00 / 22.06.12
02 Tools
1. General ................................................................................................................................................................................................ 6
2. Tools .....................................................................................................................................................................................................6
1. General
• If work is performed by people who do not have the necessary training to carry out the work or if this information
is handled carelessly or totally ignored, this may result in severe injury and/or death. Inaddition, serious damage
to the vehicle may occur.
• Always read the safety instructions in full before starting certain operations. The safety instructions stipulate
which aspects must be considered to achieve maximum safety. The information is given that is very important
for health and safety.
• Always work in adequately ventilated rooms with sufcient lighting, free from dirt and clutter. Never leave tools
or parts lying around, keep away from (high-) voltage sources that present a risk of short-circuiting. Always wear
protective clothing. Do not wear any damaged or loose-tting clothing and remove jewelry before starting the
work. In case of long hair use hairnet.
• Tool list below is a recommended list. It is not a must to use the exact same tools.
2. Tools (Recommended)
Screw Driver