Ten-Tec 4229 - Panel Mounting and Knob Attachment; Final Inspection and Preparation

atl
(
(
)
10.
Install these panels over the various shafts and switch buttons. The panel
meter sandwiches between the subpanel and the aluminum front panel and locates
in the rectangular meter opening which accepts the rectangular boss projecting
from
the
meter
case.
When
these
panels
are
fully
seated
against
the
four
cor-
ner
spacer
bushings
they
are
secured
with
four
black
6-32
x
1/2"
oval
head
screws.
Attach the various knobs on proper shafts. The large spinner type knob mounts
on the inductor shaft with the "0" marking at the vertical line on the panel
when the shaft rotation is at maximum clockwise rotation (read pointer will be
at "30" on the slide rule scale). The other large skirted knob is installled
on the capacitor shaft with the "10" marking at the vertical line on the panel
and with the rotor and stator plates fully meshed.
All assembly operations are now completed except for installing the top cover
and securing with four black 10-24 x 1/2" screws and nylon washers.
Before installing top cover, inspect for any obvious shorts, unsoldered con-
nections, and see that all shafts and controls operate properly. The completed
tuner should then be ready to test and align as covered in the Owners Manual for
the TEN-TEC Model 229 Antenna Tuner. This manual is included as part of this
kit.
«'