Ten-Tec 4229 - Page 8

ONE OF 46 <i
STATOR
SPACERS aS
or
LAST OF 24
ad STATOR PLATES
IO- 32 x6- 3/4"
STATOR RODS
FIRST OF ¢4
STATOR PLATES
FIGUBRIE 3
FRONT PLATE
ASSEMBLY
NUTS FOR: POSITIONING OF STATOR
PLATES IN RELATION TO ROTOR PLATES
ee
ae ee a ees once qe
a4 4-32 HEADLESS
ae
I
cree
AE
maa
LOCK NUT
IG
BALL BEARIN
REAR PLATE
STATOR ASSEMBLY ASSEMBLY
“TENSION. SPRING OT
WASHER ROTOR ASSEMBLY:
- a --— [_—; — mg —
ALUMINUM
i SPACER ROD
FIGURE 4
( ) 5. Fasten front and back plates with two aluminum spacer rods and 6-32 x 3/8"
screws thru holes in lower corners of front and back plates. Only tighten
slightly at this time.
( ) 6. To mount the rear end of the rotor shaft to the rear plate use the ball
bearing and 1/4-32 headless set screw. This takes some dexterity. Sug-
gest that you insert the ball in the cup recess of the set screw using a
dab of soap, wax or grease to hold it in the detent. Then carefully run
the
screw
and
ball
into
the
threaded
hole
in
the
back
plate.
Aligh
the
rear
of
the
rotor
shaft
so
that
the
ball
engages
the
recess
in
the
end
of the rotor shaft. When engaged and tightened, the set screw can be
locked
in
place
with
the
1/4-32
hex
nut
against
the
rear
plate.