9
4
Basic configuration
Startup
Shutdown
Local management
Connect the included power adapter to the power port of the NVR, and plug the power
adapter into the power socket to start up the NVR.
After the mouse and monitor are connected to the NVR, you can perform the following
settings on the NVR's GUI (exit the Full Screen interface):
Click in the upper right corner, click Shutdown , and then click OK. When “The
Device is Shut Down. Please Cut Off the Power” appears on the screen, unplug the
power adapter of the NVR.
After the mouse and monitor are connected to the NVR, you can perform quick setup.
Select the language displayed on the GUI and the time zone in which the NVR locates,
and then click OK.
Note
Note
Do not directly cut off the power supply of the NVR to force a shutdown; otherwise, the HDD
may be damaged, videos may be lost, or even the NVR may be damaged.
Use the included power adapter to power on the NVR. Abnormal power supply will cause the
NVR to not work properly, or even the NVR may be damaged.
2022 - 01 - -14
11
： 26 ： 51
Shutdown
Language
Time Zone
Date
Time
OK
ngi
s
Initial Setup
To Next Page
Loading...
