Document Version: V1.3
100
- When the NVR restores its settings, it will disconnect all current connections.
- Restoring the settings will not delete recordings and log information.
- To avoid damaging the NVR, ensure that the NVR is powered on properly during the
process of restoring the factory settings.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Configuration > Maintenance > Auto Maintenance.
Step 3 Select the channel of the camera to be rebooted, which is D1 in this example.
Step 4 Click Restore Default Settings or Restore Factory Settings according to the actual
condition.
Step 5 Read the prompt message, and click OK.
---End
Wait until the progress bar completes.
To Next Page
Loading...
