III Install the CPE
The equipment is suitable for mounting at heights > 2 m.
This CPE is usually deployed in schools, communities, factories or streets for surveillance.
Install the CPEs in an outdoor location without obstacles according to the distance and directions of the CPEs.
Thread plastic straps through slots on the brackets, adjust the direction and the place of the CPEs and tighten the straps to
attach the CPEs firmly to the holding poles.
Remove the covers and power on the CPEs. The Power indicators light up.
Connect the CPE with the LED1, LED2 and LED3 indicators solid on (AP mode – the transmitting end) to the switch which is
connected to a NVR (Network Video Recorder).
Connect the CPE with the LED1, LED2 and LED3 indicators blinking (Client mode – the receiving end) to IP cameras or a
switch which is connected to IP cameras.
With more than two CPEs bridged, the connection reaches its best when the LED1, LED2 and LED3 indicators of the CPEs all
light solid on or blink.
The application scenario is shown on the right:
To Next Page
Loading...