Wall Mounting
This router can be installed on the wall with two screws. The recommended wall mounting tools are as
follows:
[Expansion bolt] Outer diameter: 6.0mm; Length: 26.4mm
[Screws] PA3*14mm; Head diameter: 5.2mm
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in which case
the user may be required to take adequate measures.
Operations in the 5.15-5.25GHz band are restricted to indoor use only.
This equipment should be installed and operated with minimum distance 20cm between the device and your
body.
The mains plug is used as disconnect device, the disconnect device shall remain readily operable.
NOTE: (1) The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. (2) To avoid unnecessary radiation interference, it is recommended to use a
shielded RJ45 cable.
Declaration of Conformity
Hereby, SHENZHEN TENDA TECHNOLOGY CO., LTD. declares that the device is in compliance with Directive
2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://www.tendacn.com/download/list-9.html
Operating Frequency:
2.4 GHz: EU/2412-2472 MHz
5 GHz: EU/5150-5250 MHz
EIRP Power (Max.):
2.4 GHz: < 20 dBm
5 GHz: < 23 dBm
Software Version: V16.03.30.X (RX2 Pro/TX2 Pro/RX2/TX2)
V16.03.36.X (RX1 Pro/TX1 Pro/RX1/TX1)
For EU/EFTA, this product can be used in the following countries:
To Next Page
Loading...
