11N Wireless Broadband Router
43
¾ WPS mode：Provide two ways: PBC (Push-Button
Configuration) and PIN code.
¾ PBC：Select the PBC or press the WPS button on
the front panel of the device for about one second
(Press the button for about one second and WPS
indicator will be blinking for 2 minutes, which
means the WPS is enabled. During the blinking
time, you can enable another device to implement
the WPS/PBC negotiation between them. Two
minutes later, the WPS indicator will be off, which
means the WPS connection is completed. If more
clients are added, repeat the above steps. At
present, the WPS supports up to 32 clients access.)
¾ PIN：If this option is enabled, you need to enter a
wireless client’s PIN code in the field and keep the
same code in the WPS client.
¾ WPS Summary： Show the current state of Wi-Fi
protected setting, including authorized mode,
encryption type, default key and other information.
¾ WPS Current Status： Idle means WPS in idle
state. Start MSC process means the process has
been started and waits for being connected.
Configured means the negotiation is successful
between server and clients.
¾ WPS Configured： “yes” means WPS feature is
enabled and goes into effect. “not used” means it is
not used. Usually the AP-security has been enabled,
here will displayed “not used”.
¾ WPS SSID： Show the main SSID set by WPS.
To Next Page
Loading...
Need help?
General
