TENDO Unit - Factory Settings Overview; Setup Sequence and Configuration

9. Factory settings
!
Load: 50kg"
Filter: 35 cm"
Audio signal upper limit: 100%"
Audio signal lower limit: 90%"
Partial Average Power and Peak Force range: 50% Rest Time: OFF
Eccentric Average velocity (ECS): OFF
Weight setup in lbs: OFF
10. Set Up Sequence
1.
Press ON/OFF button for 3 seconds
2.
Set Load (Weight in Kg or Lb if turned on) - change by using the Up and Down arrow
buttons.
3.
Press MODE button for 3 seconds
4.
Set Load - (Weight in Kg) - second option even during the exercise set - change by using
the Up and Down arrow buttons.
5.
Press MODE button
6.
Set Filter - see list of suggested Filters in main manual Page 9
E.g. 70-90cm - Power Snatch/Clean, Clean Pull, Snatch Pull
30-40cm - Squat, Jerk, Hang Clean and Hang Snatch
30-35cm - Bench
7.
Continue down list „A-UP“, „A-LO“, „P-AP“, „r-t“, and „ECS“
8.
To quit setup menu press the RESET button.
9.
The microcomputer will show you the load (weight) in the bottom window. After 10 seconds
of the sensor standstill this will go onto RestTime measurement (if Rest Time is turned
on).
10.
SET 2 – Change Weight without resetting all the information. Press MODE button for 3
seconds. Change Load with UP and DOWN arrow buttons. Press Reset
www.tendosport.com
7