Tens AA - Advanced Operation and Placement; Waveform and Mode Selection; Intensity Adjustment and Pad Placement; Reading Usage Instructions

Press the key & simultaneously
to select the waveform. The following
waveform symbols will be displayed for 3
seconds when you press the key.
Symmetrical Bi-phasic rectangular
Monophasic rectangular
NOTE
In a very small percentage of people, using
T.E.N.S. in Monophasic Rcetangular waveform
can exacerbate the symptoms of pain. If this
occurs, stop treatment in this waveform in
immediately.
Press this key to select mode, total 5
modes are available. Constant, Burst I,
Burst II, Modul I, Modul II.
Press this key to set the treatment time.
These two knobs adjust the intensity of
channels, left side is for the Ch1, right
side is for Ch2. Turn the knob and the
intensity over zero, the corresponding
LED light located at the top of the knob
will light up.
Turn in clockwise increase the intensity.
14
STEP 4 PLACEMENT OF PADS
Ensure wherever you intend to place the pads.
that the skin is clean and thoroughly dry.
remove the pads from the clean plastic shield
and position on your body as required.
8
9
STEP 5 READING
Read section on “ Operation of the T.E.N.S.
Uint”, and decide how to use the T.E.N.S. uint
11