+
SET
2 sn. basýn
CodE
162 girin
Üst Gösterge
SET
Out
000.0.....999.9
SET
CALb
0.000.....9.999
SET
InPt
1u.2n,
2u.2u,
1u.2G,
1u.2d,
Phs.4,
Phs.1,
Phs.2
SET
ConF
0.....8
SET
dEC.P
0, 0.0, 0.00, 0.000
SET
Cr.dr
drCt, oPPo
SET
Freq
20, 500,
2500, 7500 Hz
SET
oFFS
0000.....9999
SET
SET
Prog. End.
Pon.r
YES, no
Note: If no entry is done for 20 sec. during programming, current enteries are accepted and saved to EEPROM memory.
Factory SET
Values:
PSt2: 0100
PSt1: 0050
Out1: 001.0 sec.
Out2: 001.0 sec.
CALb: 1.000
InPt: 1u.2n
ConF: 0
dEC.P: 0
Cr.dr: drCt
Freq: 20
Pon.r: YES
oFFS: 0000
PSt1: AbSt
Enter fixed password; 162
Out ON duration
for latching enter, 0.000
Calibration constant
Input options
Operating modes
options
Select place of
decimal point
Counting direction;
direct / opposite or
up/down
Max. frequency for input signal.
Select 20Hz for mechanical switch.
Offset Value;
1. If Cr.dr=drCt; Counter is set to “oFFS” with
RESET ON or panel reset.
2. If Cr.dr=oPPo; when Config=0.....6 and
Inpt=1uP.2uP, 1up.2Gt, Phase.4,
OUT2 is ON, as soon as counter reaches “oFFS”. (*)
Yes: Reset after power-on.
No: Loads the count value & output status
at the latest power failure after the first power-on.
(*) : Decimal appears at dEC.Pnt selection.
5
Programming Parameters:
To Next Page
Loading...