Cleaning and maintenance
Your grill is made of high-quality materials�
Please note: Stainless steel discolours at
high temperatures! This is not a defect, but
a sign of quality!
To clean and maintain the surfaces, please
heed the following instructions:
Danger Risk of burning!
Let the grill cool down
completely before cleaning�
– Empty the ashes once the fuel has
burned down completely and is out�
Danger Health hazard!
Do not use any paint solvents
or thinners to remove stains�
Such liquids are hazardous to
health and may not come into
contact with food�
Attention Risk of damage!
Do not use any strong or
abrasive solvents or scouring
pads as such products attack
the grill's surfaces and leave
permanent markings�
• Let the fuel burn out completely after
grilling� This eases the cleaning effort
by burning away excess fat and BBQ
residues�
• Remove the ash drawer (8) and empty
out the cold ash� It is very important
you remove the ash before moisture
comes into contact with the cold
ash. Ash contains salt and affects
the inside of the ash collection
tray when damp. Therefore the ash
collection tray can be damaged by
rust over the years.
• Clean the BBQ regularly, at best after
every use�
• Remove the BBQ grate and clean it
thoroughly in soapy water� Thoroughly
dry the grate afterwards�
• Use a wet sponge to remove loose
residue from the grill�
• Use a soft, clean cloth to dry� Be careful
not to scratch the surfaces while drying�
• In general, clean the inner and outer
surfaces with warm soapy water�
• Tighten all screws before every use to
guarantee stable footing for your BBQ
at all times�
Disposal
The packaging is made of
environmentally friendly materials
that you can dispose of at your
local recycling centre�
Do not under any circumstances
dispose of the BBQ in normal
household waste! Dispose of
it through a registered waste
disposal service or at your local
waste disposal facility� Respect
the currently valid regulations� If
you have any questions, contact
your local waste disposal facility�
Declaration of conformity
This product is in compliance with
the applicable European and national
Directives (DIN EN 1860-1)�
To Next Page
Loading...
