Ter Welding Multi 400K - HOT START MMA MODE OPERATIONS; Manual and Synergic Hot Start Adjustments

GB
English
Instruction Manual
HOT START - MMA Mode (Manual)
The value can be adjusted according to the electrode type – Ex. stainless steel and
rutile electrodes demand a low value, near
to 0 – basic and the majority of the commun
electrodes a mi-value between 30/50 – cellu-
losic electrodes require a high value.
Push the 2nd level key until “HS” icon light on
– the led will blink for two seconds and during
this time adjust the required value. Two sec-
onds after the last touch, “HS” setting mode
get off.
(see also wire feeder setting)
MMA mode (synergic)
MMA synergic welding is a really usefull way to avoid setting mistakes. Even skilled
welders can save job time entering the synergic mode:
2nd level key
Adjusting knob
A -Select STICK B – Select electrode type C – Select electrode size
HOT START - MMA Mode (Synergic)
In synergic MMA mode the value is already set according to the choosed electrode.
The parameter can be changed anyway - adjustments are diplayed in % (pourcentage)
towards the original value:
push the 2nd level key until “HS” icon light on – the led will blink for two seconds and
during this time adjust the required value. Two seconds after the last touch, “HS” setting
mode get off.
The adjustment is made using the main display knob, as usual.
The new parameter is automatically stored – it will be restored once recalling the same
program.
This setting is available only on the main generator panel.
NB: the welding current can be adjusted as well, remaining anyway inside the
programmed synergic values.
C – HS value increased of 15%
B – HS icon
A – 2nd level key
Welding Current
Adjusting knob
2nd level key
MMA
CELLULOSIC
Manual
MMA
CELLULOSIC
Manual
11