Ter Welding Multi 400K - LIST OF ALARMS; Alarm Messages and Troubleshooting Checks

GB
English
Instruction Manual
ERR. NR. DISPLAY MESSAGE ALARM CHECK
10 PHA NO PHA NO
POWER SUPPLY
CONTACT SERVICE CENTER
11 NO AC NO AC
POWER SUPPLY
CONTACT SERVICE CENTER
12 HI AC HI AC
POWER SUPPLY
CONTACT SERVICE CENTER
13 LO AC LO AC
POWER SUPPLY
CONTACT SERVICE CENTER
14 FRQ ERROR FREQUENCY OF POWER SUPPLY NETWORK
POWER SUPPLY
CONTACT SERVICE CENTER
20 CUR OVERCURRENT PROTECTION CONTACT SERVICE CENTER
21 INT (CHO) INTERNAL POWER DRIVING ALARM CONTACT SERVICE CENTER
24 HAL HALL SENSOR ALARM CONTACT SERVICE CENTER
25 CALIBRATION ALARM CONTACT SERVICE CENTER
30 °c THEMPERATURE ALARM
WAIT COOLING
CONTACT SERVICE CENTER
33 h2o WATER FLUX ALARM
CHECK WATER ON THE COOLING UNIT
CONTACT SERVICE CENTER
40 ENC ENCODER ALARM CONTACT SERVICE CENTER
41 brA BREAK MOTOR OF FEEDER ALARM CONTACT SERVICE CENTER
42 MOT SPEED MOTOR ALARM CONTACT SERVICE CENTER
50 tAb TAB ALARM CONTACT SERVICE CENTER
51 MEM MEMORY ALARM
52 i2c I2C ALARM
53 485 ALARM
60 SC SHORT CIRCUIT AT POWER ON ALARM
CHECK THE TORCH WIRE DO NOT TOUCH
THE WORK DESK
CONTACT SERVICE CENTER
LIST ALARMS