Tera Gear TER 25K BTU PRO

Questions and Answers

M
Marissa OrtizAug 15, 2025
What to do if Tera Gear TER 25K BTU PRO Grill has persistent grease fire?
- S
  Sandra SmithAug 15, 2025
  If your Tera Gear Grill has a persistent grease fire, immediately turn the knobs to the OFF position and shut off the gas supply at the propane tank. Keep the lid closed and allow the fire to burn out completely. Once the grill has cooled down, remove and thoroughly clean all of its parts. This issue is usually caused by grease trapped by food accumulating up to the burner system.
J
joann65Aug 18, 2025
Why are the flames on my Tera Gear TER 25K BTU PRO Grill turning yellow or orange?
- C
  Connie CombsAug 18, 2025
  The flames on your Tera Gear Grill may turn yellow or orange due to a couple of reasons. If it's a new burner, it might have residual manufacturing oils. In this case, burn your grill for 15 minutes with the lid closed. Also, food residue, grease, or seasoning salt on the burner can cause this issue. If that's the case, clean the burner ports.
B
Bryan KnoxAug 21, 2025
What to do if Tera Gear TER 25K BTU PRO Grill has flashback fire in burner tubes?
- J
  Jason SwansonAug 21, 2025
  If you experience flashback (fire in burner tubes) with your Tera Gear Grill, it's likely because the burners or tubes are blocked. Clean the burners or tubes to resolve this issue.
D
Denise BellAug 25, 2025
How to fix irregular flame pattern on Tera Gear Grill?
- H
  Hunter CampbellAug 25, 2025
  To fix an irregular flame pattern on your Tera Gear Grill where the flame doesn't run the full length of the burner, clean the burner ports.
K
Karen JohnsAug 28, 2025
What to do if Tera Gear TER 25K BTU PRO Grill flame blow out?
- T
  Thomas RayAug 28, 2025
  If the flame on your Tera Gear Grill blows out, especially in high or gusting winds, turn the front of the grill to face the wind or increase the flame height.
C
Cheryl JonesAug 31, 2025
Why Tera Gear TER 25K BTU PRO Grill burner doesn't light using knobs or igniter?
- A
  Amanda PetersAug 31, 2025
  If the burner on your Tera Gear Grill doesn't light using the knobs or igniter, clean the wire or electrode with rubbing alcohol.
T
Tonya RosarioSep 4, 2025
Why Tera Gear TER 25K BTU PRO Grill burner doesn't light using a match?
- K
  Kathryn PerrySep 4, 2025
  If the burner on your Tera Gear Grill doesn't light even when using a match, first check if the propane tank is empty. If the tank is not empty, refer to the Excessive flow safety valve reset procedure.
M
michelle10Sep 7, 2025
What to do if Tera Gear TER 25K BTU PRO Grill has irregular flame?
- V
  vgardnerSep 7, 2025
  If your Tera Gear Grill has an irregular flame, it could be due to incorrect air flow. If the flames are yellow or orange, open the flap at the end of the venturi tubes in 3mm (1/8 in.) increments until the flames appear correct. If the flames are blue and noisy, close the flap at the end of the venturi tubes in 3 mm (1/8 in.) increments until the flames are correct.
J
jordancraigSep 10, 2025
What to do if Tera Gear TER 25K BTU PRO Grill has sudden drop in gas flow?
- C
  Caitlin GreenSep 12, 2025
  If you notice a sudden drop in gas flow or reduced flame height on your Tera Gear Grill, follow the safety valve reset procedure. Turn off the coupling nut about one-half to three-quarters of an additional turn until it reaches a solid stop. Tighten it by hand ONLY - DO NOT use tools.