Teradek LINK User Manual

CONNECT YOUR ENCODER TO LINK
Connecting Cube/Brik to Link’s wireless network (default Link-1234,
where 1234 is replaced with the last four digits of your Link’s serial
number):
1. Enter the main menu by pressing
▲ or ● (using the menu joystick).
Select Network Setup with ▼ and
enter the menu with ▲ .
2. Select Configure.
6. Choose Yes to Apply the new
Network settings.
4. From the Infrastructure menu,
choose Scan.
3. Select Infrastructure.
7. Set your Cube’s Bonding mode to Link, found in the menus under
A/V Setup > Bonding > Mode .
5. Select Link’s network.
CONFIGURE YOUR STREAM
3
Configure the following settings on your encoder and decoder.
The settings are available via both the web UI and Cube’s front panel.
Transport Stream (License required): Used for streaming
across the internet to a decoder.
Primary Stream
Mode: MPEG Transport Stream
Transport Stream Server: Enabled
Listening Port: 5000
Decoder Settings
Mode: MPEG Transport Stream
Protocol: TCP Pull
Host: Your Sputnik Server Address
Port: 5000
sputnik
encoder
link
decoder
1. Select RTMP as the Stream Mode .
2. Enter the server URL. Depending on your destination (local server or
CDN), this will look something like rtmp://server.address:1935/live.
3. Enter the stream name. For many platforms
this is found with the server URL.
4. Click Apply.
5. Start/stop the stream by clicking the buttons on the Stream Settings
page or by pressing the Stream joystick on Cube.
6. See the reference guide for additional information.
Settings are found on Cube’s web UI under Video Setup > Stream Settings .
RTMP streaming: Used for streaming to an internet streaming platform,
CDN, or stream server.

Teradek LINK Specifications

General

WiFi Standard	802.11 a/b/g/n/ac
Max Data Rate	867 Mbps
Frequency Bands	2.4 GHz, 5 GHz
Ports	1x USB
Power	12V DC