Teradek LINK - User Manual

B
C
D
A
E
F
l nk
l nk
l nk
G H
I
J
K: Sputnik
L: Host
M: Data
N: Fault/Error
O: Stream Joystick
P: Menu Joystick
K
M
N
O
P
L
G: Power Input
H: Power Switch
I: USB Port
J: Ethernet Ports
A: Wireless Antenna
B: Stream Joystick
C: Menu Joystick
D: OLED Display
E: Status LEDs
F: USB Modem Ports
Menu Joystick:
▲,▼: Select menu items, select characters
: Back, move to higher menu level
,● (button press): Confirm selection, open selected menu
Stream Joystick:
● (button press): Cycle status screens on main display, cancel (back),
switch text entry mode
▲
▲
Attach power (A/C adapter or battery).
Attach USB modems (F).
Move power switch to the ON ‘I’ position (H).
Attach antennas via the threaded RP-SMA connectors (A).
POWER & CONNECT
1
SPUTNIK SERVER
2
1
3
4
2
AC adapter
Enter the menu on Link’s front panel ( ,●), select the Sputnik menu,
select Host, and then use the onscreen input to enter your Sputnik
server’s IP address or host name. Select OK to set the value. Please see
the Sputnik set up guide for Sputnik installation information (Available
at http://teradek.com/pages/downloads).
SPECIFY YOUR SPUTNIK SERVER’S ADDRESS
1.
3.
2.
▲

Summary

Power & Connect

Connecting Power and Peripherals

Instructions for attaching power, antennas, USB modems, and powering on the device.

Sputnik Server

Specify Sputnik Servers Address

Enter the Sputnik menu, select Host, and use onscreen input for IP address or hostname.

Connect Your Encoder to Link

Connecting Encoder to Link Network

Steps to connect an encoder to the Link's wireless network via menu navigation.

Configure Your Stream

Transport Stream Configuration

Configure Primary Stream Mode, Transport Stream Server, and Listening Port for streaming.

RTMP Streaming Setup

Configure RTMP stream mode, server URL, and stream name for streaming platforms.

Teradek LINK Specifications

General

WiFi Standard	802.11 a/b/g/n/ac
Max Data Rate	867 Mbps
Frequency Bands	2.4 GHz, 5 GHz
Ports	1x USB
Power	12V DC