Terex TA30 - Rear Axle Group - Differential Drive Head; Rear Axle Group; Differential Drive Head

1
Section 160-0020
SM 1969 4-00
DESCRIPTION
Numbers and letters in parentheses refer to Fig. 1.
Fig. 1 illustrates both a standard pinion gear and
spider differential (A) and a limited slip type (B).
Basically the differential consists of pinion gear (3) and
ring gear (5). The differential is a spiral bevel ring gear
type with an automatically operating limited slip
element (B).
The differential is mounted to the axle housing. The
1 - Bearing Adjuster
2 - Housing
3 - Pinion Gear (Drive)
4 - Drive Flange
5 - Ring Gear
6 - Spider (Pinion) Gear
7 - Side Gear
8 - Differential Case Assembly
SM - 849
Fig. 1 - Sectional View of Typical Differential
REAR AXLE GROUP - Differential Drive Head
driveline yoke attaches directly to differential
flange (4) which is splined to the shaft of pinion gear (3).
Limited Slip Assembly
Numbers in parentheses refer to Fig. 2.
The limited slip assembly consists of housing (1), thrust
washers (2), externally splined discs (3), internally splined
discs (4), thrust ring (5), side gears (6), pinion gears (7),
differential axle (8) and cover (9).
Courtesy of Machine.Market