Section 180-0022
3SM 1481 9-98
MAINTENANCE
The air suspension levelling valve does not require
any particular maintenance. It is recommended
however that a visual inspection of the control lever,
connecting rod and joints should be made at regular
intervals. In the event of a continuous air loss from
exhaust port 'C', it is recommended that the levelling
valve should be replaced as an assembly.
4. If control lever (34) is not in the horizontal (neutral)
position, disconnect connecting rod (36) and allow
control lever (34) to return to the horizontal position.
Alter length of connecting rod (36) until rod length is
set to enable it to be fitted to control lever (34) in the
horizontal position. Secure connecting rod (36) in this
position to maintain set length.
Suspension System - Levelling Valve
* * * *
Courtesy of Machine.Market
To Next Page
