3-283-28
BODY UP INTERLOCK - When the body is raised, the CEC system will onlyBODY UP INTERLOCK - When the body is raised, the CEC system will only
allow the transmission to operate in First gear. This feature is only operational inallow the transmission to operate in First gear. This feature is only operational in
the normal automatic driving mode, either power or economy. It is not activatedthe normal automatic driving mode, either power or economy. It is not activated
during the manual mode.during the manual mode.
PARKING BRAKE INTEPARKING BRAKE INTERLOCK - If the parking brake RLOCK - If the parking brake is applied while theis applied while the
transmission is in Neutral, the CEC system will transmission is in Neutral, the CEC system will prevent a shift out of prevent a shift out of Neutral toNeutral to
protect the brake components. If the parking brake is applied while the transmissionprotect the brake components. If the parking brake is applied while the transmission
is in gear, the parking brake interlock will not function and normal shifts will occur.is in gear, the parking brake interlock will not function and normal shifts will occur.
LOCK-IN-GELOCK-IN-GEAR - The lock-in-gear feature is AR - The lock-in-gear feature is designed to protect the transmissiondesigned to protect the transmission
from damage should wheel spinning or lockup occur due to poor traction or from damage should wheel spinning or lockup occur due to poor traction or panicpanic
braking. The ECU will delay making a shift for several seconds braking. The ECU will delay making a shift for several seconds and then, if theand then, if the
condition fails to correct itself, locks in gear and prevents any further shifting. Thecondition fails to correct itself, locks in gear and prevents any further shifting. The
Check Trans warning light will come on. If this occurs, the ECU must be resetCheck Trans warning light will come on. If this occurs, the ECU must be reset
before normal operation may be resumed.before normal operation may be resumed.
To reset the ECU if the transmission has locked in gear because To reset the ECU if the transmission has locked in gear because of wheel spinningof wheel spinning
or a panic stop, stop the machine, select 'Neutral', apply the parking brake, and shutor a panic stop, stop the machine, select 'Neutral', apply the parking brake, and shut
down the engine. Wait ten seconds, then restart the engine. Select 'Reverse', thendown the engine. Wait ten seconds, then restart the engine. Select 'Reverse', then
'Neutral'. The Check Trans warning light should go 'Off'.'Neutral'. The Check Trans warning light should go 'Off'.
COLD WEATHER STARTCOLD WEATHER STARTS - During cold S - During cold weather starts, if the weather starts, if the transmissiontransmission
temperature is below -24° C (-10° F) the Check Trans warning light willtemperature is below -24° C (-10° F) the Check Trans warning light will
illuminate and the ECU will prevent the transmission from being shifted out ofilluminate and the ECU will prevent the transmission from being shifted out of
Neutral. Between -24° C (-10° F) and -7° C (19° F) the light will go out and theNeutral. Between -24° C (-10° F) and -7° C (19° F) the light will go out and the
ECU will only permit operation in First ECU will only permit operation in First or Reverse gears. Above -7° C (19° F),or Reverse gears. Above -7° C (19° F),
normal operation will be permitted.normal operation will be permitted.
To Next Page
Loading...
