4-34-3
Component ChecksComponent Checks
1. Engine -1. Engine -With the engine off, checkWith the engine off, check
oil level. The oil level should beoil level. The oil level should be
between the lower and upper marksbetween the lower and upper marks
on the dipstick. Add oil if low.on the dipstick. Add oil if low.
2. Fuel Filters -2. Fuel Filters -Drain sediment andDrain sediment and
water from sump until fuel runs clear.water from sump until fuel runs clear.
3. Radiator Header Tank -3. Radiator Header Tank -CheckCheck
coolant level. Add if low.coolant level. Add if low.
WARNINGWARNING
Press button in centre of cap toPress button in centre of cap to
bleed pressure before removingbleed pressure before removing
cap completely. Fill to bottom ofcap completely. Fill to bottom of
filler neck.filler neck.
In subfreezing temperatures, be sureIn subfreezing temperatures, be sure
that the coolant contains sufficientthat the coolant contains sufficient
antifreeze.antifreeze.
4. Air Cleaner Vacuator Valve(s) -4. Air Cleaner Vacuator Valve(s) -
Check for proper operation. Clean ifCheck for proper operation. Clean if
required.required.
5. Tyres -5. Tyres -Carefully inspect all tyresCarefully inspect all tyres
for cuts, bruises, or other damage andfor cuts, bruises, or other damage and
proper inflation for the loads to beproper inflation for the loads to be
carried. Inflate all tyres to thecarried. Inflate all tyres to the
recommended pressure while cold.recommended pressure while cold.
6. Fuel Level Gauge -6. Fuel Level Gauge - Check fuelCheck fuel
level. Tank should be filled at end oflevel. Tank should be filled at end of
each shift to prevent condensation.each shift to prevent condensation.
037037
640640
041041
641641
22
225599 003388
44
11
33
66
55