Need help?Do you have a question about the TERK Technologies XMDirect XMDGM100 and is the answer not in the manual?
General| Compatibility | XM satellite radio receivers |
|---|---|
| Model Number | XMDGM100 |
| Brand | TERK Technologies |
| Type | Adapter |
| Input Voltage | 12V |
Details on vehicle compatibility and checking the website for the most updated list.
Describes the plug-and-play nature and general installation approach.
Guidelines for mounting components, securing cables, and avoiding sharp edges.
Advice on locating the XM tuner and antenna for optimal cable reach.
Instructions for removing the dashboard trim bezel to gain access to the radio.
Steps to remove mounting screws and pull the car radio out.
Disconnect existing cables, remove the radio, and connect to the supplied harness.
Install the adapter box (A3) by connecting the white connector as illustrated.
Connect RCA audio cables (W2) and 8-pin mini DIN cable (W3) to the interface box.
Route the other ends of the RCA and mini DIN cables to the XM tuner location (A2).
Mount the adapter box (A3) securely to prevent interference or rattling.
Connect the harness (W1) to the radio and the antenna cable to the radio's antenna jack.
Reinstall the radio, ensuring the harness is not crimped, and replace mounting screws and trim bezel.
Install the magnetic mount antenna (A1) as per the separate guide, typically on the roof.
Route the antenna cable to the XM tuner (A2) location.
Connect the RCA, mini DIN, and antenna cables to the XM tuner box (A2).
Securely mount the XM tuner (A2) in its final location to prevent movement.
Reassemble the dashboard, complete installation, and activate the XM tuner.
Instructions for activating the XM tuner via preview channel or phone number.
Refers to the vehicle's owner's manual for operating XM mode and understanding text display messages.
To Next Page