EasyManua.ls Logo

TERMA MOA - MOA IR Advanced Functions

TERMA MOA
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
User manual MEG, DRY, MOA, REG 2, REG 3
An-freeze funcon
When the device is o and the temperature
surrounding the temperature sensor drops
to below 6° C, the device will switch on au-
tomacally. This is to prevent the heang
agent inside the radiator from freezing. The
acvaon of An-freeze mode is indicated
by the blinking of the middle diode.
Dryer funcon
The Dryer turns the device on for 2 hours,
e.g. in order to dry a towel. Aer this peri-
od of me the device automacally switch-
es to the mode to which it was set before
the dryer mode.
In order to acvate the dryer mode, press
and hold the buon (also when the heang
element is o) – the device will start work-
ing and maintain the most recent temper-
ature seng. You can now freely adjust de-
sired temperature level (buons and ).
Aer 2 hrs heater will revert to the previous
seng (before dryer funcon acvaon).
To use 2 hrs mer heang element must be
switched o. Switch it on by pressing and
holding buon. Aer 2 hrs heater will
switch o automacally.
Press buon at any me to interrupt the
dryer mode.
Remote control mode
(wireless communicaon)
If the device is located in a room with an ex-
ternal IR controller suitable for communica-
on with the heang element, the rst signal
received by the heang element will auto-
macally acvate the recepon mode. The
device will maintain the temperature indi-
cated by the external controller while con-
nuing to limit the radiator temperature so
that it does not exceed 60°C. The remote
control mode is indicated by the middle di-
ode. In case of communicaon loss longer
than 25 minutes, the device will automa-
cally switch back to the manual mode, and
connue to operate according to the most
recent seng. Any new signal received by
the heang element, will switch it back to
the remote control mode.
The dryer funcon can be acvated in the
remote control mode (when the dryer func-
on is deacvated, the heang element will
resume the recepon of signals from the ex-
ternal controller).
Calibrang the temperature span
same as MOA
Problem solving
same as MOA

Related product manuals