To Next PageTo Next Page
Need help?Do you have a question about the TermaTech TT20 Series and is the answer not in the manual?
General| Nominal Heat Output | 5 kW |
|---|---|
| Flue Outlet Diameter | 150 mm |
| Fuel Type | Wood |
| Category | Wood stove |
| Manufacturer | TermaTech |
| Series | TT20 |
| Material | Steel |
| EPA Certified | Yes |
| Heating Capacity | 30-120 m2 |
| Burn Time | Up to 8 hours |
Specifies the necessary floor surface characteristics and load-bearing capacity for stove installation.
Instructions for configuring the stove for a rear flue pipe connection.
Details on the necessary specifications and conditions for the chimney system.
Guidance on the correct usage and limitations of flue dampers.
Explains the requirements for adequate air supply for efficient combustion.
Instructions and recommendations regarding chimney sweeping.
Details on the approved intermittent burning method for the stove.
Step-by-step guide for the first time lighting the stove, including paint curing.
Specifies the maximum amount of fuel that can be loaded into the combustion chamber.
Information about the grate's function for ignition and ash removal.
Alerts users that stove surfaces, handles, and chimney pipes become extremely hot during operation.
Guidance on safely relighting the stove after a period of non-use.
Recommendations for storing firewood to ensure optimal moisture content.
Instructions for safely disposing of stove ashes to prevent ignition.
Guidance on adjusting air controls for stoves that burn too aggressively.
Diagnosing and resolving issues related to weak chimney draft or poor combustion.
Overview of daily maintenance tasks and annual inspection requirements.
Steps for cleaning the firebox, including removal of insulation plates if necessary.
Procedure for safely removing and replacing damaged or worn firebox insulation panels.
Guidance on lubricating and maintaining door hinges and closure mechanisms.
Information on maintaining door gaskets for airtightness and when to replace them.
Instructions for cleaning and maintaining the stove's painted exterior surfaces.
Methods for repairing minor scratches on the stove's painted finish.
Maintenance advice for stoves with soapstone or sandstone cladding.
Recommended methods for cleaning the stove's glass window.
Recommendation to use only genuine TermaTech spare parts for repairs.
Reference to section 8 for details on various stove settings and adjustments.
Information on the standard and extended warranty periods offered by TermaTech.
Lists parts within the fire chamber that are not covered by the warranty.
Lists exterior components and finishes excluded from warranty coverage.
Details common causes and situations that invalidate the product warranty.
Describes minor product variations that do not qualify for warranty claims.
Recommended minimum distances to non-combustible surfaces for optimal performance.
Specifies minimum clearances to combustible materials for safe installation.
Required safety clearances when using uninsulated flue pipes.
Specifies safety clearances required when using insulated flue pipes with the stove.
Procedure for safely removing and replacing firebox insulation panels.
Instructions on how to adjust or disable the automatic door closing feature.
Guide to adjusting the stove's levelling feet for stability and alignment.
Steps for setting up the stove, including levelling and floor protector installation.
Instructions for adjusting the height or level of the stove's top plate.
Procedure for correctly installing heat storage stones into the stove.
Guidance on adjusting the hinges of the wood compartment door for proper fit.
How to adjust the air draft through the stove door using magnets.
Installation guide for the external combustion air intake kit, item number 09-170.
Installation guide for the external combustion air intake kit, item number 09-162.
Instructions for installing the damper control unit in smoke control areas.
Guidelines for recycling cardboard packaging materials.
Guidelines for recycling plastic and styrofoam packaging materials.
Guidelines for recycling wooden pallets and framing from packaging.
Information on how to dispose of vermiculite, insulation panels, and gaskets.
Instructions for disposing of ceramic glass, differentiating it from regular glass.
Guidelines for the proper disposal of natural stone cladding.
Recommendations for recycling the main steel or cast iron components of the stove.
Lists the standards and certifications the wood stove series has been tested against.
Provides the dimensions and volume of the stove's combustion chamber.
Presents key performance data obtained during product testing.
Building regulations regarding the mandatory installation of CO alarms.
Information on smoke control areas and exemptions under the UK Clean Air Act.
General precautions to ensure Health and Safety at Work Act compliance during installation.
Guidance on safe handling of materials and components during installation.
Safety warning regarding the handling of caustic fire cement.
Advice on handling potential asbestos disturbances during installation.
Safety advice for avoiding personal injury when working with metal parts.
Reference to manual for details on the stove's operational performance.
Essential preparatory work and safety checks before commissioning the stove.
Specific chimney requirements and regulations applicable in the UK.
Detailed technical drawings and measurements for TT20 and TT20R models.
Technical drawings and measurements for TT20Bazic and TT20Bazic R models.
Detailed technical drawings and measurements for TT20S and TT20RS models.
Technical drawings and measurements for TT21R and TT21SA models.
Technical drawings and measurements for TT21RS Black and Grey models.
Detailed technical drawings and measurements for the TT21RS-SA model.
Technical drawings and measurements for the TT21RL model.
Detailed technical drawings and measurements for the TT21RLS model.
Technical drawings and measurements for the TT21RH model.
Detailed technical drawings and measurements for the TT21RHS model.
Technical drawings and measurements for the TT21RHT model.
Detailed technical drawings and measurements for the TT21RS-HST model.
Technical drawings and measurements for the TT21RHS-HST model.
Manufacturer's declaration confirming compliance with EU regulations for Danish market.
List of EU directives and regulations the product complies with.
Table showing the product's performance against emission limit values.
