ENGLISH
• To “liven up” the clothes hung on coat hangers, curtains etc. you can vertically
use the iron:
• Set the temperature adjustment knob (9) on MAX indication.
• Hold the iron in vertical position at a distance of about 15-20 cm from the fabric.
• Push the super-steam button (5) several times.
Note:
• Don’t consecutively push the button too many times respecting the pauses of some
seconds between one operation and another after.
IMPORTANT!
•
• Maintain an adequate distance between the fabric and the ironing plate to avoid
burning.
• Use this function exclusively on clothes hung on coat hangers. Don’t ever try to iron
the clothes worn by a person: the steam is very hot, you could cause serious burning.
VERTICAL IRONING
• Your iron is supplied with a self-cleaning system which allows to reduce the
to regularly effectuate the operation, at least once a month. Proceed as following:
• Set the dry ironing function.
• Fill up the tank up to MAX level
• Make the iron function as normal bringing the plate to the maximum temperature.
• Disconnect the plug from the current socket when the iron is ready.
• Set the steam adjustment control (4) on the symbol (
the iron in horizontal position over a sink or a bowl, until the tank is empty.
) “self cleaning”, and leave
• * Then rotate the control (4) until it is set to “0”.
• • Afterwards connect the plug to the current socket and moving the iron above an
old cloth, eliminate all the residue water present in the plate.
IMPORTANT!
• Pay attention not to get in contact with the water that is comes out from the
plate since it is bowling and you could get burned.
NOTE:
• Before re-using the iron to iron the clothing, pass the cold plate on a dry cotton cloth.
SELF-CLEANING SYSTEM
water drops.
• Use this function only with the temperature adjustment knob (9) set up to the steam
function.
• When
To Next Page
