17
Maintenance
CAUTION: Replacement parts are not lubricated.
Replacement parts must be lubricated at
time of assembly and during use, per the lube
manufacturer’s recommendations.
PTO Shaft Lubrication
NOTE: See page 15 for recommended service intervals in
Maintenance Schedule table.
1. Lubricate all ttings with lithium soap compatible E.P.
grease meeting the N.L.G.I. #2 specications and
containing no more than 1% molybdenum disulde.
2. An E.P. grease meeting N.L.G.I. #2 specications
and containing 3% molybdenum disulde may be
substituted in the telescoping members only.
3. The rotating guard bushings should be lubricated
upon replacement.
Cleaning and Seasonal Storage
1. Empty the hopper before removing from the tractor.
2. Raise the hopper lid and clean the screen using a
cloth or soft-bristle brush.
3. Carefully remove any debris stuck to the fan and spray
with a light oil to prevent rusting.
4. Remove shields and clean out debris stuck in drive
frame. Reinstall the shields before storing.
To Next Page
Loading...