Need help?Do you have a question about the TerraMaster D5-300C and is the answer not in the manual?
General| RAID levels | 0, 1, JBOD |
|---|---|
| Data transfer rate | 5 Gbit/s |
| Hot-swap drive bays | Yes |
| Storage drives installed | No |
| Storage drive sizes supported | 2.5, 3.5 \ |
| Supported storage drive types | HDD & SSD |
| Total installed storage capacity | 0 TB |
| Maximum supported storage capacity | 80 TB |
| Number of storage drives installed | 0 |
| Number of storage drives supported | 5 |
| Supported storage drive interfaces | Serial ATA |
| Noise level | 19.8 dB |
| Chassis type | Desktop |
| Fan diameter | 80 mm |
| Certification | CE, FCC, CCC, KC |
| Product color | Black, Grey |
| LED indicators | HDD, Power |
| Number of fans | 2 fan(s) |
| Sustainability certificates | RoHS |
| Device class | Home & Home Office |
| AC input voltage | 100-240 V |
| DC output voltage | 12 V |
| AC input frequency | 50 - 60 Hz |
| Number of power supply units | 1 |
| Power supply unit (PSU) capacity | 90 W |
| Mac operating systems supported | macOS |
| Cables included | AC |
| Number of adapters included | 1 pc(s) |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 5 - 40 °C |
| Operating relative humidity (H-H) | 5 - 95 % |
Weight and Dimensions| Depth | 136 mm |
|---|---|
| Width | 225 mm |
| Height | 227 mm |
| Weight | 2100 g |
| Package depth | 186 mm |
| Package width | 275 mm |
| Package height | 300 mm |
| Package weight | 3500 g |
Indicators for hard drives 1 and 2, showing status like ready, reading/writing, or fault.
Indicators for hard drives 3, 4, and 5, showing status like ready, reading/writing, or fault.
Indicates the power status of the device, showing if it is powered on or off.
Button to power on the device with a short press or power off with a long press.
Port for connecting the DC 12V power adapter for device operation.
Interface used for data transmission between the device and a computer.
Used to switch RAID modes, requires reset to take effect.
Button to reset the device to match its current hardware settings.
Steps to recover data from a faulty hard drive in RAID 1 configuration.
To Next Page
