Digital
Output
:
Use the “Enable” button to enable or disable the digital output. The digital output can only be
enabled in “Stereo Speaker” or “Headphone” mode.
You can also select the sampling frequency that you want to use.
Input:
LoopBack
This button loops the digital input to the digital output.
Monitor
The signal from the digital output is looped to the analog output here.
Validity Detection
When this is enabled, a check is made for a valid S/PDIF signal.
Copyright protection
If this field is enabled, the signal output at the digital output has a copy bit. This means that if
you record a digital signal while copyright protection is enabled, no further recordings can be
made from this signal.
SoundSystem Aureon 5.1 PCI (English) 23
To Next Page
Loading...
