WARNING: Model 3 cannot detect
obstacles that are located lower than
the bumper, are very narrow, or are
hanging from a ceiling (for example,
bicycles). In addition, many
unforeseen circumstances can impair
Summon's ability to move in or out of
a parking space and, as a result,
Summon may not move Model 3
appropriately. Therefore, you must
continually monitor the vehicle's
movement and its surroundings and
remain prepared to stop Model 3 at
any time.
Operating Summon with the Key
NOTE: Summon may not operate if the key
fob accessory's battery is low.
Follow these steps to park Model 3 from
outside the vehicle using the key fob
accessory:
1. On the touchscreen, ensure that Require
Continuous Press is disabled (touch
Controls > Autopilot > Summon > Require
Continuous Press > NO).
2. With Model 3 in Park, stand within 3
meters and press and hold the top center
button on the key fob accessory (Lock/
Unlock All button) until the hazard lights
blink continuously.
NOTE: The hazard lights flash once as
Model 3 locks, then within five seconds,
Model 3 powers on and the hazard lights
flash continuously. Do not proceed to the
next step until the hazard lights are
flashing. If, after five seconds, the hazard
lights are not
flashing, release the button
on the key fob accessory, move closer to
Model 3, and try again. If Summon receives
no further input within ten seconds,
Summon cancels.
3. Press the Front Trunk button on the key
fob accessory to move Model 3 forward
into the parking space, or press the Rear
Trunk button to reverse
Model 3 into the
parking space.
Starting Summon Before Exiting
the Vehicle
To start a Summon parking sequence before
exiting Model 3:
1.
On the touchscreen, ensure that Require
Continuous Press is disabled (touch
Controls > Autopilot > Summon > Require
Continuous Press > NO).
2. Close all doors and trunks.
3. With Model 3 powered on and the Park
gear engaged, double press the Park
button on the gear stalk. The touchscreen
displays a popup window.
4. On the touchscreen, choose the direction
of travel.
5. Exit Model 3 and close the driver's door.
Summon now moves Model 3 according to
the direction you specified on the
touchscreen.
NOTE: To cancel the parking maneuver before
exiting, touch Cancel on the popup window.
NOTE: If you do not choose a direction of
travel on the touchscreen, Summon does not
start a parking maneuver when you exit.
Stopping or Canceling Summon
You can stop Model 3 at any time while
Summon is active by using the mobile app or
by pressing any button on the key fob
accessory. Summon also cancels when:
• A door handle is engaged or a door is
opened.
• You interact with the steering wheel,
brake pedal, accelerator pedal, or gear
stalk.
• Model 3 detects an obstacle.
• Summon has moved Model 3 the
maximum distance of approximately 12
meters.
• Your phone enters sleep mode or loses
connectivity to Model 3.
Limitations
Summon is unlikely to operate as intended in
the following types of situations:
• The driving path is sloped. Summon is
designed to operate on flat roads only (up
to 10% grade).
Summon
130 MODEL 3 OWNER'S MANUAL
To Next Page
Loading...
