• A raised concrete edge is detected.
Summon will not move the vehicle over an
edge that is higher than approximately 2.5
cm.
• One or more of the ultrasonic sensors is
damaged, dirty, or obstructed (such as by
mud, ice, or snow, or by a vehicle bra,
excessive paint, or adhesive products such
as wraps, stickers, rubber coating, etc.).
• Weather conditions (heavy rain, snow,
fog, or extremely hot or cold temperatures)
are interfering with sensor operation.
• The sensors are aected by other
electrical equipment or devices that
generate ultrasonic waves.
NOTE: Summon is disabled if Model 3 is in
Valet mode (see Valet Mode on page 58).
WARNING: The list above does not
represent an exhaustive list of
situations that may interfere with
proper operation of Summon. It is the
driver's responsibility to remain in
control of Model 3 at all times. Pay
close attention whenever Summon is
actively moving Model 3 and stay
prepared to take immediate action.
Failure to do so can result in serious
property damage, injury or death.
Summon
131Autopilot
To Next Page
Loading...
