Tesla MODEL 3 2020 - Page 153

◦ Park Assist Chimes: If on, you an audible beep sounds when approaching an object while
parking (see Park Assist on page 83).
◦ Joe Mode: When enabled, Joe Mode lowers the volume of your vehicle's chimes, except
for turn signals.
◦ Security Alarm: Enable the security alarm (see Security Settings on page 176).
◦ Tilt/Intrusion: (if available) Enable a siren that sounds if Model 3 detects motion inside the
cabin or if the vehicle is moved or tilted (see Security Settings on page 176).
◦ PIN to Drive: Increase security by preventing Model 3 from being driven until a 4-digit PIN
(Personal Identification Number) is entered (see PIN to Drive on page 176).
◦ Cabin Overheat Protection: Reduce the temperature of the cabin in extremely hot
ambient conditions for a period of up to twelve hours after you exit Model 3 (see Cabin
Overheat Protection on page 159).
◦ Allow Mobile Access: Allow Tesla's mobile applications to access your Model 3 (see Mobile
App on page 186).
NOTE: To disable Allow Mobile Access, enter your Tesla account credentials on the
touchscreen.
◦ Data Sharing: Allow sharing of road measurement data (see Data Sharing on page 242).
NOTE: Sentry Mode and Cabin Overheat Protection operate only when the energy remaining
in the Battery is above 20%.
Service
◦ Wiper Service Mode: Make wiper blades easy to access (see Wiper Blades and Washer
Jets on page 213).
◦ Adjust Headlights: Make adjustments to the level of the headlights (see Headlight
Adjustments on page 70).
CAUTION:
Headlights should only be adjusted by Tesla Service.
◦ Towing: Prepare Model 3 for transporting by keeping it in Neutral (which disengages the
parking brake and prevents damage to the rear motor that is caused by wheels turning as
Model 3 is pulled onto a flatbed truck). See Instructions for Transporters on page 235.
◦ Reset TPMS Sensors: Reset the TPMS sensors after replacing a wheel (see Manually
Resetting TPMS Sensors on page 205).
◦ Factory Reset: Erase all personal data (saved addresses, music favorites, etc.) and restore
all customized settings to their factory defaults.
◦ Wheel Configuration: Update your vehicle's wheel configuration if you are installing new
wheels or swapping them for dierent ones. This also changes the wheels of your vehicle's
avatar on the touchscreen.
NOTE: Changing your vehicle's wheel configuration can impact range estimates, tire
pressure warning levels, and vehicle visualization. See Tire Care and Maintenance on page
201 for more information.
WARNING:
Only use Tesla-approved wheels when installing or swapping wheels.
Using non Tesla-approved wheels can cause serious damage. Tesla is not liable for
damage caused by using wheels not approved by Tesla.
◦ Owner's Manual: Display this manual. You can also display this manual by touching the
Tesla "T" at the top of the touchscreen.
Software
Controls
151Using the Touchscreen