4.
Connect the low voltage power supply's
red positive (+) cable to the red positive
(+) terminal on the
low voltage battery.
CAUTION: To avoid damaging
Model Y, do not allow the positive
cable to contact other metal
components, such as the battery
tie-down bracket.
5.
Connect the low voltage power supply's
black negative (-) cable to the black
negative (-) terminal on the low voltage
battery.
6.
Turn on the external power supply (refer
to the manufacturer’s instructions). Touch
the touchscreen to wake it up.
NOTE: It may take several minutes to
receive enough power to wake up the
touchscreen.
7. When external low voltage power is no
longer required, disconnect both cables
from the terminals on the battery,
beginning with the black negative (-)
cable.
8. Reinstall the cabin intake trim panel by
placing it back in its original location and
pressing down until it is secure.
9. Replace the maintenance panel by placing
it back in its original location and pressing
down until it is secure.
10. Close the hood.
Jump Starting the Low Voltage
(Lithium-Ion) Battery
1. Open the hood (see Opening Hood with
No Power on page 19).
2.
Remove the maintenance panel by pulling
it upwards to release the trim clips that
hold it in place.
3.
If equipped with a HEPA filter, carefully
fold the HEPA
filter gasket towards the
front of the vehicle to gain access to the
low voltage jump post.
4. Pull back the black seal to reveal the
positive jump post. Remove the red cover
and connect the external low voltage
power supply’s red positive (+) cable to
the red positive (+) jump post.
Instructions for Transporters
228 MODEL Y Owner's Manual
To Next Page
Loading...
