6
ENG
Notes for heating
Notes for turning off
Emergency operation
Airflow direction adjustment
Specific caution
• The fan of the indoor unit will not start running immediately after the heating is started to avoid blowing out cool
air.
• When it is cold and wet outside, the outdoor unit will develop frost over the heat exchanger which will increased
the heating capacity. Then the air conditioner will start defrost function.
• During defrost, the air conditioner will stop heating for about 5-12 minutes.
• Vapor may come out from the outdoor unit during defrost. This is not a malfunction, but a result of fast defrost.
• Heating will resume after defrost is complete.
• When the air conditioner is turned off, the main controller will automatically decide whether to stop immediately
or after running for dozens of seconds with lower frequency and lower air speed.
• If the remote controller is lost or broken, use force switch
button to operate the air conditioner.
• If this button is pushed with the unit OFF, the air
conditioner will operate in Auto mode.
• If this button is pushed with the unit ON, the air
conditioner will stop running.
1. Use up-down swing and left-right swing buttons on the remote
controller to adjust the airflow direction. Refer to the operation
manual of the remote controller for detail.
2. For models without left-right swing function, the fins has to be
moved manually.
Note: Move the fins before the unit is in operation, or your finger
might be injured. Never place your hand into the air inlet or outlet
when the air conditioner is in operation.
1.Open front panel of the indoor.
2. The connector (as Fig) can not touch the terminal
board, and is positioned as shown in Fig.
Force switch
Connector
Cable 1
Cable 2
Terminal board
To Next Page
Loading...
Need help?
General
