Tesla TT34EX82BM-1232IAW

Questions and Answers

J
Jessica MyersAug 2, 2025
What to do if my Tesla TT34EX82BM-1232IAW makes strange noises during operation?
- E
  Emily FullerAug 2, 2025
  If you notice strange noises during the operation of your Tesla Air Conditioner, immediately switch it off and cut off the power supply. Then, inspect the electronic control board, fuses, and switches for any faults, replacing them if necessary. Also, check for overheated cables or plugs and replace them if damaged. Remove any water or objects inside the appliance and inspect for any strong smells, removing their source.
J
Joshua DuncanAug 7, 2025
How to get rid of strange odor from Tesla TT34EX82BM-1232IAW Air Conditioner?
- J
  Jorge SimonAug 7, 2025
  If you notice a strange odor coming from your Tesla Air Conditioner, the most likely cause is a dirty air filter. Try cleaning or replacing the air filter to resolve the issue.
C
Curtis BarnesAug 11, 2025
Why my Tesla Air Conditioner does not operate?
- J
  Jamie WrightAug 11, 2025
  If your Tesla Air Conditioner isn't operating, start by checking the power supply, ensuring that the plug is properly connected and there isn't a power failure. Then, check for loose connections and make sure the voltage is within the specified range. Also, verify that the TIMER-ON function is deactivated. If these steps don't resolve the issue, inspect the indoor/outdoor unit fan motor, compressor thermomagnetic circuit breaker, fuses, and electronic control board for any damage, replacing them as needed. It may also sometimes stop operating to protect the appliance, so allow the appliance to reset.
F
farleycarlaAug 15, 2025
What to do if my Tesla TT34EX82BM-1232IAW Air Conditioner does not respond to commands?
- A
  Abigail MooreAug 15, 2025
  If your Tesla Air Conditioner is not responding to commands, first ensure that the remote control is close enough to the indoor unit. If that doesn't work, replace the remote control batteries. Also, make sure there are no obstacles between the remote control and the signal receiver on the indoor unit.
H
Hailey ThomasAug 20, 2025
How to improve insufficient airflow in Tesla Air Conditioner?
- C
  chelsea48Aug 20, 2025
  If your Tesla Air Conditioner is not providing sufficient airflow, whether hot or cold, start by adjusting the temperature setting and increasing the fan speed. Clear any obstructions from the air conditioner intakes and outlets. Additionally, clean or replace the air filter if it's dirty. Eliminate any other heat sources in the room. If the issue persists, the unit may need refrigerant replenished.
B
Brian OliverAug 25, 2025
Why is the display off on my Tesla Air Conditioner?
- J
  Jeremy WoodAug 25, 2025
  If the display on your Tesla Air Conditioner is off, first check the power supply to ensure there isn't a power failure. If power is available, try deactivating the LIGHT function.
N
Nancy ElliottAug 28, 2025
What causes the noise of running water in Tesla TT34EX82BM-1232IAW Air Conditioner?
- N
  nmaddoxAug 28, 2025
  If you hear the noise of running water in your Tesla Air Conditioner, it could be due to back flow of liquid in the refrigerant circulation. In this case, you should check the refrigerant circulation.

Summary

USER MANUAL

SPLIT-TYPE AIR CONDITIONER

Title indicating the type of appliance covered.

OPERATING INSTRUCTION

SAFETY RULES AND RECOMMENDATIONS FOR THE INSTALLER

SAFETY RULES AND RECOMMENDATIONS FOR THE USER

SAFETY RULES AND PROHIBITIONS

NAMES OF PARTS

Indoor unit

List and description of components for the indoor air conditioner unit.

Outdoor unit

List and description of components for the outdoor air conditioner unit.

INDOOR UNIT DISPLAY

EMERGENCY & AUTO-RESTART FUNCTION

REMOTE CONTROLLER

Meaning of symbols on the liquid crystal display

Replacement of Batteries

OPERATING INSTRUCTIONS

Swing control of the air flow

How to adjust the air flow direction using the remote control.

Modes of Operation

Cooling mode

How to use the cooling function to lower room temperature and humidity.

Heating mode

How to use the heating function to warm the room.

Dry mode

How to use the dry mode to reduce air humidity.

Fan mode

How to use the fan mode for ventilation only.

Auto mode

How to use the auto mode for automatic temperature regulation.

Special Functions

ECO function

How to activate the energy-saving ECO mode.

Turbo function

How to activate the Turbo function for rapid cooling or heating.

Sleep function

How to activate the Sleep function for optimized night-time operation.

Mildew function

How to activate the Mildew function to dry internal parts.

Timer and Cleaning Functions

Self-clean function

How to activate the self-cleaning function to remove dirt and bacteria.

8°C heating function

How to set the unit to maintain a minimum temperature of 8°C.

Timer function

How to set, change, or cancel the timer for automatic operation.

I FEEL Function and Operating Temperature

I FEEL function

How the I FEEL function optimizes comfort by sensing room temperature.

Operating Temperature

Recommended temperature ranges for various operating modes and climates.

INSTALLATION MANUAL

Important considerations

Key factors and precautions before proceeding with installation.

Installation Safety Principles

Special Tools

Selecting the Installation Place

Indoor unit

Specific recommendations for positioning the indoor unit.

Outdoor unit Installation

Installation Diagram

Visual representation of the unit placement and clearances.

Mounting Plate Installation

Wall Piping and Electrical Connections

Drilling a hole in the wall for the piping

How to drill the wall hole for refrigerant piping and drainage.

Electrical connections-Indoor unit

Steps for connecting the electrical wiring to the indoor unit.

Refrigerant Piping and Water Drainage

Refrigerant piping connection

How to connect the refrigerant pipes between the indoor and outdoor units.

Indoor unit condensed water drainage

How to ensure proper drainage of condensed water from the indoor unit.

Unit Installation Procedures

Installation of the indoor unit

Detailed steps for mounting and securing the indoor unit.

Installation of the outdoor unit

Guidelines for securely installing the outdoor unit.

Outdoor unit condensed water drainage

How to manage condensate water from the outdoor unit in heat pump models.

Electrical connections

Connecting the power supply to the outdoor unit.

Pipe Connection and Refrigerant Handling

Connecting the pipes

Instructions for securely connecting refrigerant pipes with flare nuts.

Bleeding

Process of removing air and moisture from the refrigerant circuit using a vacuum pump.

Refrigerant Pressure Inspection

How to check refrigerant pressures to ensure proper system operation.

Valve Diagram and Operation Testing

3-way valve diagram

Visual representation of the 3-way valve and refrigerant flow direction.

Operation test

Steps to verify the correct functioning of the air conditioner after installation.

Indoor unit test

Checks to perform on the indoor unit to ensure proper operation.

Installer Information and Torque Specifications

Outdoor unit test

Checks to perform on the outdoor unit for noise, vibration, and leaks.

Tightening torque for protection caps and flange connection

Recommended torque values for securing pipe connections.

Wiring Diagrams and Cable Specifications

Cable wires specification

Details on wire types, sizes, and specifications for different capacities.

Cable Wire Specifications by Type

MAINTENANCE

Indoor unit maintenance

Steps for cleaning filters and the heat exchanger of the indoor unit.

End of season maintenance

Tasks to perform after the cooling or heating season ends.

Replacing the batteries

Instructions for replacing batteries in the remote controller.

TROUBLESHOOTING

Error Signals on the Display

INSTRUCTION FOR SERVICING