Prior to operate the set-up of the machines, check that:
The machines are connected through the special connecting cable
The ground devices are installed and connected
The gear-box configuration is HIGH-PULL in each machine
5.2 MACHINES SET-UP
Before the use the machine must be set in connected mode by assign to each machine the correct ID
number, starting from left to right, as described in the previous chapter.
a. insert and turn the ignition key (table 1, pos. 17) in “1” position
b. wait up to the multifunction display switch on (table 1, pos. 14)
c. on the electronic multifunction display press the () key
d. on the screen page “MACHINE ID:” set the correct number by using the up () or down () key
e. press the return key ( ) to save the settings
To Next Page
Loading...
