PULLER-TENSIONER
Model: AFB506
Manual: MI-AFB506-149-00-GB
NOTE: the ID of the machines
must be set from 1 to the total
number of connected machines
starting from left to right (looking
at the machines from the back –
reel-winder position)
h. on the screen page “BULL WHEELS PIN CONNECTION?” set the “YES” or “NO” option,
depending on the configuration of use, by using the up () or down () key
i. press the return key ( ) to save the settings
j. set each machine in connection configuration, except the final one, by turning rightwards
the selector (table 1, pos. 42-44)
To Next Page
Loading...
