PULLER-TENSIONER
Model: AFS404
Manual: MI-AFS404-609-01-GB
Prior to operate the set-up of the machines, check that:
The machines are connected through the special connecting cable
The ground devices are installed and connected
The gear-box configuration is HIGH-PULL in each machine (optional)
5.2 MACHINES SET-UP
Before the use of the machine must be set in connected mode to be assigned to each machine the
correct ID number, starting from left to right, as described in the previous chapter.
a. insert and turn the ignition key (table. 3, pos. 14) in position “1”
b. wait until the switching of the multi-function display (table. 3, pos. 17)
c. on the page “MACHINE ID:” set the correct number using the key up ( ) or down ( )
push the enter key ( ) to save the settings
To Next Page
Loading...
