Testboy TV 325 - Functions; MODE Key

Functions
36 Testboy
®
TV 325
Functions
MODE key
By pressing the mode key, you can switch between the various
measurement functions:
"MIN" Displays the lowest temperature value found during the
measurement
"MAX" Displays the highest temperature value found during the
measurement
"DIF" Shows the difference between the highest and the lowest
temperature value
"AVG" Shows the average value
After the Testboy
®
TV 325 has been turned off; the measured temperature
values can be shown again by pressing the MODE key. With each new
measurement, the value of the old measurement is overwritten and replaced
with the new one. You can also use the MODE key to set the alarm values
for "high alarm" (HAL), "low alarm" (LAL) and emissivity (E). The Testboy
®
TV 325 changes the function with each press of the MODE key.
Use the MODE key to set the alarm values and emissivity as needed. Use
the two arrow keys to set the required value.