TestEquity FastRate 3007C - Default Chapter; Table of Contents

Table of Contents
Chapter 1 – Safety Instructions ________________________________________________ 1-1
Introduction ____________________________________________________________________ 1-1
Installation Safety Notices _________________________________________________________ 1-1
Operation Safety Notices __________________________________________________________ 1-3
Chapter 2 – Installation ______________________________________________________ 2-1
Uncrating _______________________________________________________________________ 2-1
Preparation For Use ______________________________________________________________ 2-1
Installation Location _____________________________________________________________ 2-1
Condensate Drain ________________________________________________________________ 2-2
Input Power Configuration ________________________________________________________ 2-2
230 V / 60 Hz Input Configuration (for 240 V lines) ___________________________________________ 2-3
208 V / 60 Hz Input Configuration _________________________________________________________ 2-3
Connection to the Power Source ____________________________________________________ 2-3
Power Source Connection ________________________________________________________________ 2-3
Phase Sequence ________________________________________________________________________ 2-3
LN2 (Liquid Nitrogen) Installation (Option 0018) _____________________________________ 2-4
Chapter 3 – Operation _______________________________________________________ 3-1
Introduction ____________________________________________________________________ 3-1
Summary of Chamber Operation ___________________________________________________ 3-1
Front Panel Switches and Lights ____________________________________________________ 3-2
Main Disconnect Switch _________________________________________________________________ 3-2
CONDITIONING Switch – ON Mode ______________________________________________________ 3-2
CONDITIONING Switch – EVENT 1 Mode _________________________________________________ 3-2
LIGHT Switch_________________________________________________________________________ 3-2
HEAT Light __________________________________________________________________________ 3-2
COOL Light __________________________________________________________________________ 3-2
Loading the Chamber ____________________________________________________________ 3-3
Port Plugs ____________________________________________________________________________ 3-3
Performance Considerations ______________________________________________________________ 3-4
Avoiding Moisture _____________________________________________________________________ 3-4
Internal Test Fixtures ___________________________________________________________________ 3-4
LN2 (Liquid Nitrogen) Boost Cooling (Option 0018) ___________________________________ 3-1
Purge __________________________________________________________________________ 3-1
GN2 (Gaseous Nitrogen) Installation (Option TE-0031) ________________________________________ 3-1
Dry Air Installation (Option TE-0034) ______________________________________________________ 3-1
Purge Operation _______________________________________________________________________ 3-1
Adjusting the Purge Flow ________________________________________________________________ 3-1
Digital Event Outputs ___________________________________________________________________ 3-2
Event Relays __________________________________________________________________________ 3-2
Chapter 4 - Limit Controller __________________________________________________ 4-1
Introduction ____________________________________________________________________ 4-1
Limit Controller Keys and Displays ________________________________________________________ 4-2
How to Set the High and Low Temperature Safety Limits _______________________________________ 4-2
Resetting an Out of Limit Condition ________________________________________________________ 4-2
Silencing the Audible Alarm ______________________________________________________________ 4-2
Protecting an Energized Test Sample _______________________________________________________ 4-3
Chapter 5 – Frequently Asked Questions ________________________________________ 5-1
Chapter 6 – Specifications ____________________________________________________ 6-1
Model 3007C Chamber Specifications _______________________________________________ 6-1