TESTO 177 - Setting Up the Connection with ComSoft

15
7. Programming
7.3 Setting up the connection
1 Start testo ComSoft software.
2 Select Instrument > Autodetect... .
- Autodetect opens.
- The connection to the data logger found is set up
automatically and the name of the connection appears in the
Data window.
-or-
2 Select Instrument > New device .
- The New device setup wizard opens.
3 Select testo175-177 in Device selection and click on Next .
4 Select the interface in Connection , with which you have
connected your data logger to your PC and click on Next .
5 Enter a name for the connection and click on Finish .