TESTO 410-2 User Manual

Short manual testo 410-2 11
Short manual testo 410-2
 Protection cap: Park position
 Impeller
 Humidity/temperature sensor
 Display
 Control keys
 Battery compartment (on rear)
Basic ssettings
Instrument off >press and hold 2s > select with ( ),
confirm with ( ):
Unit of temperature: °C, °F > Unit of humidity: %, td (dew point) > WB (wet bulb) >
Unit of velocity: m/s, km/h, fpm, mph, kts, Beau > Auto off-Funktion: OFF, ON
Switching tthe iinstrument oon
Press .
Switching tthe ddisplay llight oon ((for 110s)
Instrument on > press .
Select ddisplay ssize
Instrument on > select with :
Velocity, humidity, wind chill temperature ( )
Select ddisplay mmode
Instrument on > select with :
Current reading > Hold: Readings are held > Max: Maximum values > Min: Minimum
values > Hold Avg: Timed mean value calculation, see below
Timed mmean vvalue ccalculation ffor fflow
Press several times, until
Hold and Avg appear > Hold down
until
---- appears > Releasing starts mean value calculation,
the current readings are displayed > End measurement: press
the mean value is displayed.
Switching tthe iinstrument ooff:
Instrument on >press and hold 2s.
de
en
fresitptsvnl????

TESTO 410-2 Specifications

General

Measurement Parameters	Air velocity, Temperature, Humidity
Air Velocity Range	0.4 to 20 m/s
Temperature Range	-10 to +50 °C
Humidity Range	0 to 100 %RH
Resolution (Air Velocity)	0.1 m/s
Resolution (Temperature)	0.1 °C
Resolution (Humidity)	0.1 %RH
Accuracy (Temperature)	±0.5 °C
Display	LCD
Power Supply	2 x AAA batteries
Operating Temperature	-10 to +50 °C
Storage Temperature	-20 to +70 °C
Dimensions	133 x 46 x 25 mm
Units	m/s, °C, %RH
Measuring Principle	Vane anemometer