Need help?Do you have a question about the Tetra IN 600 plus and is the answer not in the manual?
Attach suction cups to the mounting unit and the air intake tube to the venturi air intake before installation.
Attach filter to aquarium glass using suction cups, ensuring diffuser is below water surface and air intake is above.
Adjust water flow by turning the adjuster clockwise to increase or counterclockwise to decrease.
Set oxygen concentration by adjusting the venturi air intake towards the back or front of the filter.
Rotate the multidirectional water diffuser to direct water flow, up to a maximum of 180 degrees.
Clean or replace foam filter media regularly to maintain efficiency. Use aquarium water for rinsing.
Clean the impeller unit each time filter media is cleaned or replaced, removing it from its housing.
Filter is guaranteed for two years against faulty material or workmanship; excludes normal wear and tear.
Always isolate the unit from mains electricity before maintenance. Supervise children.
General| Internal | Yes |
|---|---|
| Aquarium capacity (max) | 100 L |
| Aquarium capacity (min) | 50 L |
| Number of filter chambers | 2 |
To Next Page
