11
You can program your universal remote control to ‘learn’ the functions of your
device’s original remote control keys. For best performance of this learning
function, we recommend using new batteries in the original remote control.
All keys can be learned, except the DEVICE, SET and LEARN keys.
The remote can save up to 14 learned keys. When you attempt to program
the fteenth key, the rst learned setting will be erased.
To map key functions from your device’s original remote control, follow the
steps below:
1. Place your device’s original remote control in front of your universal
remote control at a distance of about 3cm.
2. Press and hold the LEARN key on your universal remote control, then
press a DEVICE key (for example DVD), the LED slowly ashes. Release
both buttons, your remote has now entered learn mode.
3. Press the key (for example the POWER key) on your universal remote to
be learned. The LED on your remote stays lit, waiting to receive a learning
signal.
4. Press and hold the matching key on the original remote. The LED on your
remote ashes twice quickly and stays lit. Release the key on the original
remote, the LED on the remote ashes slowly to indicate key mapping
has been successful.
5. Repeat steps 3-4 for each key you want your
remote to learn.
6. Your universal remote will exit learning mode if you press the LEARN key
and no key is pressed or learning signal received for 10 seconds.
NOTE : When exiting learning mode, the previously learned setting will be
saved.
7. If you have already used the learn function for a device key (for example,
a TV) and now want the remote to learn a dierent TV’s remote control
keys, you must rst erase the previously learned codes. To erase learned
codes for one device: press the DEVICE key
(for example, TV), then
press and hold the SET key and while holding the SET key, press the
4 (number) key and hold both keys for 3 seconds.
Operation (Cont.)
Learn key function
55484
2 x AAA batteries
To Next Page
Loading...
