7
Setup
Your universal remote control can operate a TV, VCR, DVD or a cable/satellite
set top box. Set
up your universal remote in one of three ways:
• Brand Code Setup: Directly enter the device code from the Code List.
Try each code until you nd one that works for your
device.
• Auto Code Search: Your universal remote automatically goes through all
the device codes. (This method can take up to 45
minutes to search all the codes for the three devices.)
• Manual Code
Search: Manually goes through each code for your device
one by one at the touch of the button.
• Learn Key Function: Manually programs each key using the original
remote of the device you want to program.
NOTE: Keep your remote control pointed at the device that you want to
program throughout the setup.
Brand code setup
1. Power on the device that you want to control.
2. Find the code (or codes) for your device in the included Code List. If your
device’s brand is not listed, use the Auto Code Search or Manual Code
Search method.
3. On your universal remote, press and hold SET and then, while holding
SET , press a device key (TV, VCR/DVD or STB/CBL).
The red LED lights and stays lit, indicating that the remote is in setup
mode. Release both buttons.
NOTE: Do not hold down the keys for longer than three seconds or the
remote enters auto search mode.
4. Enter the rst 3-digit code for your device and brand. Pause briey
between each digit to make sure the remote receives all inputs. The red
LED ashes when input is received, then turns o if you entered the right
code. If the red LED stays lit, enter the next code for your device and
brand. Repeat for all possible codes until the red LED turns o.
5. Verify the setup by testing the remote control’s buttons and functions.
If some of your device’s functions do not respond to the remote, repeat
steps 3-5 with another code.
To Next Page
Loading...
