Texas Automation Products DES-32

Need help?

Do you have a question about the Texas Automation Products DES-32 and is the answer not in the manual?

Summary

Introduction to the DES-32 Pneumatic Heat Seal Machine

Installing the DES-32

Unpacking and Inspecting the DES-32

Instructions for removing and checking components.

Locating and Securing the DES-32

Guidance on placing the machine for operation.

Electrical and Compressed Air Requirements

Specifies voltage, Hertz, and air pressure needs.

Connecting the Electrical Power Supply

Steps to connect the machine to a power source.

Connecting Compressed Air

Procedure to connect the air supply line.

Setting or Adjusting the Air Line Pressure

How to set the air regulator and view conversion data.

Turning on Power to the DES-32

Instructions for powering on the machine and entering monitoring mode.

General Operating Principles

Actuating the DES-32

How to start a heat sealing cycle.

Using the Emergency Release Pushbutton

Procedure to stop the machine immediately in an emergency.

Using the DES-32 Control Panel

Layout of the Control Panel

Explains the arrangement of controls on the panel.

Start-up and Monitoring Mode

Describes the initial state and display of the control panel.

Setting Cycle Dwell Time

Setting Top Platen Temperature

Setting Bottom Platen Temperature

Setting Air Line Pressure (PSI) Lockout Range

Cycle Count

Setting a Control Lockout Sequence