Move the blinking cursor to On and press ENTER. Leave the Type where it is above (if
you have a different type selected, use the arrows to highlight the same icon as above and
press ENTER). Your Xlist should be L1 and the Ylist should be L2. (If they are not, use
the arrows to move the cursor and change them. L1 is a 2
nd
function above 1, so to get
L1 type 2
nd
1.) The mark can be any of the three, but I find the box to be easiest to read.
We are now ready to graph the scatter diagram.
Press ZOOM.
You should see the following on your screen:
Now scroll down (or up) until you
reach option 9: ZoomStat
Press ENTER and, if everything goes according to plan, you will obtain your scatter
diagram. NOTE: We could have also obtained ZoomStat by pressing 9 in the ZOOM
menu.
ZOOM
To Next Page
Loading...
