Texas Instruments TI-84 Plus

To Next Page

Step 4

Step 6

Step 7

Step 8

Your Passion. Our Technology. Student Success.

™

TI-84 Plus & TI-84 Plus Silver Edition

Press-to-Test

This feature will delete all RAM and Archive except for the disabled Apps

and Programs when using operating system 2.40 or greater.

SET-UP INSTRUCTIONS

1. Begin with the graphing calculator powered OFF.

2. Hold down both the LEFT and RIGHT arrow keys and press ON –

all three keys simultaneously.

3. Release and the calculator will start with the RESET OPTIONS screen.

4. By default, ANGLE mode is set to DEGREE and STAT DIAGNOSTICS are ON.

To change settings, use the ARROW keys and press

(These are the default settings for the calculator.)

5. Once your selections have been completed, press OK.

(press the ZOOM button located just below the screen).

6. The RESET COMPLETE screen will appear. Press any key to continue.

7. Press the APPS key, which should display an

“APPS HAVE BEEN DISABLED” message.

8. Press the PRGM key, which should display a

“PROGRAMS HAVE BEEN DISABLED” message.

= illustration shown.

RESTORE INSTRUCTIONS ON REVERSE SIDE.

Press-to-Test for TI-84 Plus & TI-84 Plus Silver Edition

Other manuals for Texas Instruments TI-84 Plus

Need help?

Do you have a question about the Texas Instruments TI-84 Plus and is the answer not in the manual?

General

Battery type	AAA
Power source	Battery
Number of batteries supported	4
Type	Graphing
Cover	No
Form factor	Pocket
Control type	Buttons
Product color	Black
USB port	Yes
USB 2.0 ports quantity	1
Digits	- digits
Display number of lines	8 lines
Display number of characters	16
RAM capacity	0.024 MB
ROM capacity	0.480 MB
Storage media type	-