RAM Modules
Installing the Modules
After removing the keyboard, install the four RAM modules as follows. You do not need
any tools.
Caution: Prevent component damage caused by electrostatic discharge (ESD).
Use a high-impedance, grounded conductive floor mat or wrist strap to prevent ESD.
Before touching the integrated circuit devices, discharge static electricity from your
hands, tools, and containers by touching them to a grounded surface.
1. Remove the RAM modules from their shipping container to prevent
bending their pins and possible static damage.
2. Holding the first module so that the label side faces the left side of the
computer and the beveled comer faces the rear of the computer, carefully
insert the module pins into the leftmost 20-pin socket (labeled XU I 1).
Gently press down on the module to fully insert the pins into their
sockets.
TravelMate 3000 Options 6-5
To Next Page
Loading...
